EasyManuals Logo

NETGEAR FVS318G User Manual

NETGEAR FVS318G
422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #184 background imageLoading...
Page #184 background image
Firewall Protection
184
NETGEAR ProSAFE VPN Firewall FVS318G v2
Add DMZ WAN Outbound Services screen for IPv6
Services screen
These are the default QoS profiles that are preconfigured and that cannot
be edited:
Normal-Service. Used when
no special priority is given to the traffic. IP packets are
marked with a ToS value of 0.
Minimize-Cost. Used
when data must be transferred over a link with a lower cost. IP
packets are marked with a ToS value of 2.
Maximize-Reliability. Used when
data must travel to the destination over a reliable link
and with little or no retransmission. IP packets are marked with a ToS value of 4.
Maximize-Throughput.
Used when the volume of data transferred during an interval is
important even if the latency over the link is high. IP packets are marked with a ToS value
of 8.
Minimize-Delay. Used whe
n the time required (latency) for the packet to reach the
destination must be low. IP packets are marked with a ToS value of 16.
Configure Service Groups
A firewall is a security mechanism that lets network administrators selectively block or allow
certain types of traffic in accordance with rules that they specify.
When you create a firewall rule, you select a service to which the firewall rule applies. Use
the Service Group scree
n to create custom service groups for which firewall rules can be
defined. Once defined, the new service group appears in the Service list of the screens you
use to add or edit firewall rules.
To add a custom service group:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the User
name field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your persona
lized
password. Leave the domain as it is (geardomain).
c. Click the L
ogin button.
The Router Status screen displays. After five minutes of inactivity,
which is the default
login time-out, you are automatically logged out.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR FVS318G and is the answer not in the manual?

NETGEAR FVS318G Specifications

General IconGeneral
Power requirements12V DC, 1.5A
Firewall throughput250 Mbit/s
Maximum data transfer rate1000 Mbit/s
HTTP performance6000 transactions/sec
Wi-FiNo
DHCP serverYes
Number of VLANs256
VPN tunnels quantity12
WAN connectionEthernet (RJ-45)
Connectivity technologyWired
Ethernet LAN (RJ-45) ports9
Ethernet DMZ ports quantity1
Routing protocolsRIP-1, RIP-2
Supported network protocolsTCP/IP, UDP, ICMP, PPPoE
VPN supportIPsec (ESP), IKE, PKI, HTTPS
Security algorithms128-bit AES, 192-bit AES, 256-bit AES, 3DES, DES, MD5, SHA-1
Internal memory128 MB
Flash memory32 MB
Storage media typeFlash
Processor frequency300 MHz
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 45 °C
Cables includedLAN (RJ-45)
Weight and Dimensions IconWeight and Dimensions
Weight590 g
Dimensions (WxDxH)190 x 125 x 35 mm

Related product manuals