NETGEAR FVS318G User Manual

Introduction
19
NETGEAR ProSAFE VPN Firewall FVS318G v2
Log In to the VPN Firewall
Note: To connect the VPN firewall physically to your network, connect the
cables and restart your network according to the instructions in the
NETGEAR ProSAFE VPN Firewall FVS318G v2 Installation Guide.
To configure the VPN firewall, you must use a web browser such as Microsoft Internet
Explorer 7.0 or later, Mozilla Firefox 4.0 or later
, or Apple Safari 3.0 or later with JavaScript,
cookies, and SSL enabled.
 To log in to the VPN firewall:
1. Open any of the qualified web browsers.
2. In the address field, enter h
ttps://192.168.1.1.
The NETGEAR Configuration Manager Login screen d
isplays.
The VPN firewall factory default IP address is 192.168.1.1. If you cha
nge the IP address,
you must use the IP address that you assigned to the VPN firewall to log in to the VPN
firewall.
3. In the Us
ername field, enter admin.
Use lowercase letters.
4. In the Pas
sword / Passcode field, enter password.
Use lowercase letters.

NETGEAR FVS318G Specifications

General

Power requirements	12V DC, 1.5A
Firewall throughput	250 Mbit/s
Maximum data transfer rate	1000 Mbit/s
HTTP performance	6000 transactions/sec
Wi-Fi	No
DHCP server	Yes
Number of VLANs	256
VPN tunnels quantity	12
WAN connection	Ethernet (RJ-45)
Connectivity technology	Wired
Ethernet LAN (RJ-45) ports	9
Ethernet DMZ ports quantity	1
Routing protocols	RIP-1, RIP-2
Supported network protocols	TCP/IP, UDP, ICMP, PPPoE
VPN support	IPsec (ESP), IKE, PKI, HTTPS
Security algorithms	128-bit AES, 192-bit AES, 256-bit AES, 3DES, DES, MD5, SHA-1
Internal memory	128 MB
Flash memory	32 MB
Storage media type	Flash
Processor frequency	300 MHz
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Cables included	LAN (RJ-45)

Weight and Dimensions

Weight	590 g
Dimensions (WxDxH)	190 x 125 x 35 mm