Default Settings and Technical Specifications
400
NETGEAR ProSAFE VPN Firewall FVS318G v2
Factory Default Settings
You can use the factory default Reset button on the rear panel to reset all settings to their
factory defaults. This is called a hard reset (for more information, see Revert to Factory
Default Settings on p
age 341).
To perform a hard reset, press and hold the factory default Reset butt
on for approximately
eight seconds (until the Test LED blinks rapidly). The VPN firewall returns to the factory
configuration settings that are shown in the following table.
Pressing the factory default Reset button
for a shorter period causes the VPN firewall to
reboot.
The following table shows the default co
nfigu
ration settings for the VPN firewall:
Table 86. VPN firewall factory default configuration settings
Feature Default Behavior
Login settings
User login URL https://192.168.1.1
Admi
nistrator user name (case-sensitive) admin
Administrator login password (case-sensitive) password
Guest user name (case-sensitive) guest
Guest login password (case-sensitive) password
WAN settings
WAN IPv4 mode NAT
W
A
N IPv6 mode IPv4 only mode
Stateless IP/ICMP Translation (SIIT) Disabled
WAN MAC address Use default MAC address of the VPN
firewall
WAN MTU size 1500 bytes
1492 bytes for PPPoE connections
Port speed AutoSense
Dynamic DNS for IPv4 Disabled
To Next Page
Loading...
Need help?
General
Weight and Dimensions
