Monitor System Access and Performance
361
NETGEAR ProSAFE VPN Firewall FVS318G v2
c. Click the Login button.
The Router Status screen displays. After five minutes of inactivity
, which is the default
login time-out, you are automatically logged out.
2. Select Moni
toring
> Firewall Logs & E-mail.
The Firewall Logs & E-mail screen displays.
3. Enable the syslog server and enter 19
2.168.10.2 as the IP address. at Site 1
4. Click the Ap
ply button.
Your changes are saved.
The VPN tunnel is established automatically, and the syslogs are
sent to the syslog server at
Site 1. You can use the IPSec VPN Connection Status screen to verify the connection.
View the Status
This section contains the following topics:
• View the System Status
• View the VPN Connection Status and L2TP Users
• View the VPN Logs
• View the Port Triggering Status
• View the WAN Port Status
• View the Attached Devices and the DHCP Log
View the System Status
When you start the VPN firewall, the default screen that displays is the Router Status screen.
The Router Status screen and Detailed Status screen provide real-time i
nformation about the
following important components of the VPN firewall:
• Firmware version
• Bot
h IPv4 and IPv6 WAN and LAN port information
• Interface statistics
• VLAN sta
tus, including port memberships
The Tunnel Status screen provides real-time information about the IPv6 tunne
ls.
These status screens are described in the following sections:
• Router Status
• Router Statistics
• Detailed Status
• VLAN Status
To Next Page
Loading...
