Monitor System Access and Performance
376
NETGEAR ProSAFE VPN Firewall FVS318G v2
3. In the upper right of the screen, click the Status option arrow.
The type of connection determines the information that is displayed on t
he Connection
Status screen. The screen can display the information that is described in the following
table:
To establish the connection, click the Connect bu
tton.
To disconnect the connection, click the Disconnect b
utton.
View the Attached Devices and the DHCP Log
The LAN Groups screen shows the network database, which is the Known PCs and Devices
table, which contains all IP devices that VPN firewall discovered on the local network. The
LAN Setup screen lets you access the DHCP log.
View the Attached Devices
The Known PCs and Devices table contains a list of all known computers and network
devices that are assigned dynamic IP addresses by the VPN firewall, were discovered by
other means, or were manually added. Collectively, these entries make up the network
Table 85. Connection Status screen information for an IPv6 connection
Item Description
Connection Time The period that the VPN firewall is connected through the WAN port.
IPv6 Connection Type The connection type can be either Dynamic IP (DHCP), Static, or PPPoE.
IPv6 Connection Status The connection status can be either Connected or Disconnected.
IP Address The IPv6 addresses that were automatically detected or th
at you
configured on the Broadband ISP Settings (IPv6) screen.
Note: The Gateway and DNS Server (IPv6) fields apply only to static IPv6
and PPPoE IPv6 connections.
Note: For more information, see Use a DHCPv6 Server to Configure an
IPv6 Internet Connection on page 40 and Configure a Static IPv6 Internet
Connection on page 42.
Gateway
Primary DNS Server (IPv6)
Seco
ndary DNS Server (IPv6)
To Next Page
Loading...
