NETGEAR FVS318G - Page 375

Monitor System Access and Performance
375
NETGEAR ProSAFE VPN Firewall FVS318G v2
To establish the connection, click the Connect button.
To disconnect the connection, click the Disconnect but
ton.
IPv6 WAN Port Status
 To view the IPv6 status of the WAN port:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen d
isplays.
b. In the Username
field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click the Logi
n button.
The Router Status screen displays. After five minutes of inactivity
, which is the default
login time-out, you are automatically logged out.
2. Select Network
Con
figuration > WAN Settings > Broadband ISP Settings (IPv6).
The Broadband ISP Settings (IPv6) screen displays.
IP Address The addresses that were automatically detected or that you configured on the
Broadband ISP Settings (IPv4) screen.
Note: For more information, see Let the VPN Firewall Automatically Detect and
Configure an IPv4 Internet Connection on page 28 and Manually Configure an IPv4
Internet Connection on page 31.
Subnet Mask
Gateway
DNS Server
DHCP Server DHCP only. The DHCP server that was automatically detected. This field displays
only if your ISP does not require a login and the IP address is acquired dynamically
from your ISP. You configured these ISP settings on the Broadband ISP Settings
screen.
Note: For more information, see Let the VPN Firewall Automatically Detect and
Configure an IPv4 Internet Connection on page 28 and Manually Configure an IPv4
Internet Connection on page 31.
Lease Obtained DHCP only. The time when the DHCP lease was obtained.
Lease Duration DHCP only. The period that the DHCP lease remains in effect.
Table 84. Connection Status screen information for an IPv4 connection (continued)
Item Description