IPv4 and IPv6 Internet and Broadband Settings
34
NETGEAR ProSAFE VPN Firewall FVS318G v2
9. In the Domain Name Server (DNS) Servers section, specify the DNS settings as described
in the following table.
See the following figure.
Table 4. Internet IP address settings
Setting Description
Get Dynamically
from ISP
If your ISP did not assign you a static IP address, select the Get Dynamically from ISP
radio button. The ISP automatically assigns an IP address to the VPN firewall using
DHCP network protocol.
Client Identifier If your ISP requires the client identifier information to assign an
IP address using DHCP, select the Client Identifier check box.
Vendor Class Identifier If your ISP requires the vendor class identifier information to
assign an IP address using DHCP, select the Vendor Class
Identifier check box.
Use Static IP
Address
If your ISP assigned you a fixed (static or permanent) IP address, select the Use Static
IP Address radio button, and enter the following settings:
IP Address The static IP address assigned to you. This address identifies
the VPN firewall to your ISP.
IP Subnet Mask The subnet mask is usually provided by your ISP.
Gateway IP Address The IP address of the ISP’s gateway is usually provided by
your ISP.
Table 5. DNS server settings
Setting Description
Get Automatically
from I
SP
If your ISP did not assign any Domain Name Server (DNS) addresses, select the Get
Automatically from ISP radio button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
