IPv4 and IPv6 Internet and Broadband Settings
33
NETGEAR ProSAFE VPN Firewall FVS318G v2
8. In the Internet (IP) Address section of the screen, configure the IP address settings as
described in the following table.
See the following figure. Click the Current IP Address lin
k to see the assigned IP
address.
Other (PPPoE)
Note: For login
and password
information, see
Step 3 and Step 5.
If you installed login software, your connection type is PPPoE. Select this radio button,
and enter the following settings:
Account Name The valid account name for the PPPoE connection.
Domain Name The name of your ISP’s domain or your domain name if your ISP
assigned one. You can leave this field blank.
Idle Timeout Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period, select
the Idle Timeout radio button and, in the Idle Timeout field, enter
the number of minutes to wait before disconnecting. This is useful if
your ISP charges you based on the period that you are logged in.
Connection
Reset
Select the Connection Reset check box to specify a time when the
PPPoE WAN connection is reset, that is, the connection is
disconnected momentarily and then reestablished. Then specify the
disconnect time and delay.
Disconnect
Time
Specify the hour and minutes when the connection
should be disconnected.
Delay Specify the period in seconds after which the
connection is reestablished.
Table 3. PPTP and PPPoE settings (continued)
Setting Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
