IPv4 and IPv6 Internet and Broadband Settings
32
NETGEAR ProSAFE VPN Firewall FVS318G v2
5. If you selected the Yes radio button, enter the login name in the Login field and the
password in the Password field.
This information is provided by your ISP.
6. In the ISP Type section, select the type of ISP connection that
you use from the two listed
options.
7. If your connection is PPTP or PPPoE, your ISP requires an initial
login.
Enter the settings as described in the following table:
Table 3. PPTP and PPPoE settings
Setting Description
PPTP
Note: For login
and password
information, see
Step 3 and Step 5.
If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this
radio button, and enter the following settings:
Account Name The account name is also known as the host name or system name.
Enter the valid account name for the PPTP connection (usually your
email ID assigned by your ISP). Some ISPs require you to enter
your full email address here.
Domain Name Your domain name or workgroup name assigned by your ISP, or
your ISP’s domain name. You can leave this field blank.
Idle Timeout Select the Keep Connected radio button to keep the connection
always on. To log out after the connection is idle for a period, select
the Idle Timeout radio button and, in the Idle Timeout field, enter
the number of minutes to wait before disconnecting. This is useful if
your ISP charges you based on the period that you are logged in.
My IP Address The IP address assigned by the ISP to make the connection with the
ISP server.
Server IP
Address
The IP address of the PPTP server.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
