Firewall Protection
148
NETGEAR ProSAFE VPN Firewall FVS318G v2
The DMZ WAN Rules screen displays. The IPv4 radio button is selected by default. The
screen displays the IPv4 settings.
3. Click
the Add
table button under the Outbound Services table.
4. Enter the settings as described in T
able 29 on page 128.
In addition to selections from the Service, Action, and Log list
s, you must make
selections from the following lists:
• DMZ Users
• W
AN Users
Unless your selectio
n from the Action
list is BLOCK always, you also must make
selections from the following lists:
• Select Sc
hedule
• QoS Priority
• NAT IP (This list is available only whe
n the WAN mode is NAT. If you select Single
Address, the IP address specified must fall under the WAN subnet.)
5. Click
the Appl
y button.
Your changes are saved.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
