Virtual Private Networking Using IPSec and L2TP Connections
219
NETGEAR ProSAFE VPN Firewall FVS318G v2
6. Click the Apply button.
Your changes are saved.
7. Configure a VPN policy on the remote gateway that allows connection to the VPN firewall.
8. Activate
the IPSec VPN connection:
a. Select VPN > Connection S
tatus.
b. Locate the policy in the table, and click the Connec
t table button.
The IPSec VPN connection becomes active.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
Enter the LAN IPv6 address of the remote gateway.
Note: The remote LAN IPv6 address must be different from the local LAN
IPv6 address. For example, if the local LAN IPv6 address is FEC0::1, the
remote LAN IPv6 address could be FEC0:1::1 but could not be FEC0::1. If
this information is incorrect, the tunnel fails to connect.
IPv6 Prefix Length Enter the prefix length for the remote gateway.
a. Both local and remote endpoints must be defined as either FQDNs or IP addresses. A combination of an IP address and
an FQDN is not supported.
Table 42. IPSec VPN Wizard settings for an IPv6 gateway-to-gateway tunnel (continued)
Setting Description
To Next Page
Loading...
