NETGEAR FVS318G - Page 221

Virtual Private Networking Using IPSec and L2TP Connections
221
NETGEAR ProSAFE VPN Firewall FVS318G v2
2. Select VPN > IPSec VPN > VPN Wizard.
3. To display the wizard default settings, in the upper right of the
screen, click the VPN Wizard
default values option arrow.
A pop-up screen displays, showing the wizard default values. After you complete the
wizard,
you can modify these settings for the tunnel policy that you set up.
4. Complet
e
the settings as described in the following table:
Table 43. IPSec VPN Wizard settings for a client-to-gateway tunnel
Setting Description
About VPN Wizard
This VPN tunnel will connect
to the following
peers
Select the VPN Client radio button. The default remote FQDN (remote.com)
and the default local FQDN (local.com) display in the End Point Information
section.
Connection Name and Remote IP Type
What is the new Connection
Name?
Enter
a
descriptive name for the connection. This name is used to help you to
manage the VPN settings; the name is not supplied to the VPN client.
What is the pre-shared key? Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway, or the remote VPN client. This key must be a minimum
of 8 characters and cannot exceed 49 characters.