Manage Users, Authentication, and VPN Certificates
301
NETGEAR ProSAFE VPN Firewall FVS318G v2
The policies submenu tabs display, with the Login Policies screen in view.
4. Click the By
Source IP Address submenu tab.
5. In the Defined Addresses Status section, select one of the following
radio buttons:
• Deny Login from Defined Addresses.
Deny logging in from the IP addresses in the
Defined Addresses table.
• Allow Login only from Defined Addresses.
Allow logging in from the IP addresses
in the Defined Addresses table.
6. Click
the Ap
ply button.
Your changes are saved.
7. In the Add Defined Addresses section, add an address to the Defined
Addresses table by
entering the settings as described in the following table:
8. Click the Ad
d table button.
The address is added to the Defined Addresses table.
9. Repeat St
ep 7 and Step 8 for any other addresses that you want to add to the Defined
Addresses table.
Table 69. Defined addresses settings for IPv4
Setting Description
Source Address Type Select the type of address from the list:
• IP Address.
A single IPv4 address.
• IP Network.
A subnet of IPv4 addresses. You must enter a netmask length in
the Mask Length field.
Network Address / IP
Address
Depending on your selection from the Source Address Type list, enter the IP
address or the network address.
Mask Length For a network address, enter the netmask length (0–32).
Note: By default, a single IPv4 address is assigned a netmask length of 32.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
