Network and System Management
342
NETGEAR ProSAFE VPN Firewall FVS318G v2
When you press the hardware factory default Reset button or click
the software Default button, the VPN firewall settings are erased. All
firewall rules, VPN policies, LAN and WAN settings, and other
settings are lost. Back up your settings if you intend to use them.
After you reboot with factory default settings, the VPN firewall’s password is password, and
the LAN IP address is 192.168.1.1.
Reset Button Method
To reset the VPN firewall to the original factory defaults settings:
Using a sharp object, press and hold for about e
ight seconds the factory default Reset
button on the rear panel of the VPN firewall.
The Test LED lights and blinks for about 30 seconds.
The VPN firewall reboots. The reboot process takes about 165 seconds. The
reboot
process is comple
te when the Test LED on the front panel turns off.
Management Interface Method
To reset the VPN firewall to the original factory defaults settings:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the User
name field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your persona
lized
password. Leave the domain as it is (geardomain).
c. Click the L
ogin button.
The Router Status screen displays. After five minutes of inactivity,
which is the default
login time-out, you are automatically logged out.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
