LAN Configuration
98
NETGEAR ProSAFE VPN Firewall FVS318G v2
3. Enter the settings as described in the following table:
Table 18. DMZ Setup screen settings for IPv4
Setting Description
DMZ Port Setup
Do you want to
enabl
e DMZ Port?
Select one of the following radio buttons:
• Yes.
Enables you to configure the DMZ port settings. Complete the IP
Address and Subnet Mask fields.
• No. Allows you to disable the DMZ port after you configure it.
IP Addre
ss Enter the IP address of the DMZ port. Make sure that the DMZ
port IP address and LAN port IP address are in different
subnets (for example, an address outside the LAN DHCP
address pool, such as 192.168.1.101 when the LAN DHCP
pool is 192.168.1.2–192.168.1.100). The default IP address for
the DMZ port 176.16.2.1.
Subnet Mask Enter the IP subnet mask of the DMZ port. The subnet mask
specifies the network number portion of an IP address. The
subnet mask for the DMZ port is 255.255.255.0.
DHCP for DMZ Connected Computers
Disable DHCP Server If another device
on
your network is the DHCP server for the VLAN, or if you intend
to manually configure the network settings of all of your computers, select the
Disable DHCP Server radio button to disable the DHCP server. This is the default
setting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
