NETGEAR ProSAFE SRX5308 - Page 122

Security Mode Configuration Commands
122
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
translate_to_port_number
enable
Y or N Enables or disables port
forwarding.
translate_to_port_number
port
number The port number (integer) if port
forwarding is enabled. Valid
numbers are 0 through 65535.
wan_destination_ip_address
WAN1, WAN2, WAN3, WAN4, or RANGE Specifies the type of destination
WAN address for an inbound rule:
• WAN1, WAN2, WAN3, or WAN4.
The IP address of the selected
WAN interface.
• RANGE. A range of public IP
addresses, which you need to
configure by issuing the
wan_destination_ip_address_start
and
wan_destination_ip_address_end
keywords and specifying IPv4
addresses.
wan_destination_ip_address_start
ipaddress The start IP address if the
wan_destination_ip_address
keyword is set to RANGE.
wan_destination_ip_address_end
ipaddress The end IP address if the
wan_destination_ip_address
keyword is set to RANGE.
LAN user addresses or LAN group and WAN user addresses
lan_user address_wise ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
Specifies the type of LAN address.
The address_wise and
group_wise keywords are
mutually exclusive.
For an inbound rule, this option is
available only when the WAN mode
is Classical Routing.
lan_user_start_ip ipaddress There are two options:
• The IP address if the lan_user
address_wise keywords are
set to SINGLE_ADDRESS.
• The start IP address if the
lan_user address_wise
keywords are set to
ADDRESS_RANGE.
lan_user_end_ip ipaddress The end IP address if the
lan_user address_wise
keywords are set to
ADDRESS_RANGE.
Keyword (might consist of two
separate words)
Associated Keyword to Select or
Parameter to Type
Description