NETGEAR ProSAFE SRX5308 - Page 169

Security Mode Configuration Commands
169
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Command example:
SRX5308> security address_filter mac_filter configure
security-config[mac-filter]> enable Y
security-config[mac-filter]> policy Block-And-Permit-Rest
security-config[mac-filter]> save
Related show command: show security address_filter mac_filter setup
security address_filter mac_filter source add
This command adds a new MAC address to the MAC address table for the source MAC
address filter. After you have issued the security address_filter mac_filter
source add command, you enter the security-config [mac-filter-source] mode, and then you
can add a MAC address.
Command example:
FVS318N> security address_filter mac_filter source add
security-config[mac-filter-source]> address a1:b2:c3:de:11:22
security-config[mac-filter-source]> save
security-config[mac-filter-source]> address a1:b2:c3:de:11:25
security-config[mac-filter-source]> save
Related show command: show security address_filter mac_filter setup
Keyword Associated Keyword to
Select or Parameter to Type
Description
enable Y or N Enables or disables the source MAC address filter.
policy Permit-And-Block-Rest
or
Block-And-Permit-Rest
Specifies the policy of the source MAC address filter.
Step 1 Format security address_filter mac_filter source add
Mode security
Step 2 Format address <mac address>
Mode security-config [mac-filter-source]
Keyword Associated
Parameter to Type
Description
address mac address The MAC address that needs to be added to the MAC address
table for the source MAC address filter.