NETGEAR ProSAFE SRX5308 - Page 257

VPN Mode Configuration Commands
257
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
In addition to a policy name, policy type, and destination object type, configure the
following for all addresses (that is, the destination_object_type keyword is set to
All):
ip_version {IPv4 | IPv6}
start_port <port number>
end_port <port number>
service_type {VPNTunnel | PortForwarding | All}
policy_permission {Permit | Deny}
Mode vpn-config [sslvpn-policy-settings]
Keyword Associated Keyword to
Select or Parameter to Type
Description
policy_name policy name The policy name (alphanumeric string).
policy_type Global, Group, or User Specifies the SSL VPN policy type:
• Global. The policy is global and includes all
groups and users.
• Group. The policy is limited to a single group.
For information about how to create groups,
see SSL VPN Authentication Group
Commands. You need to issue the
policy_owner keyword and specify the
group name.
• User. The policy is limited to a single user.
For information about how to create user
accounts, see SSL VPN User Commands.
You need to issue the policy_owner
keyword and specify the user name.
policy_owner group name or user name Specifies the owner of the policy. The owner
depends on the setting of the policy_type
keyword:
• Group. Specify the group name to which the
policy applies.
• User. Specify the user name to which the
policy applies.