NETGEAR ProSAFE SRX5308 - Page 258

VPN Mode Configuration Commands
258
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
destination_object_type
NetworkResource,
IPAddress, IPNetwork, or
All
Specifies the policy destination type, which
determines how the policy is applied, and, in
turn, which keywords you need to issue to
specify the policy:
• NetworkResource. The policy is applied to
an existing IPv4 or IPv6 resource. For
information about how to create and
configure network resources, see SSL VPN
Resource Commands. You need to issue the
following keywords and their associated
parameters and keywords:
- policy_name
- ip_version
- resource_name
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
• IPAddress. The policy is applied to a single
IPv4 or IPv6 address. You need to issue the
following keywords and their associated
parameters and keywords:
- policy_name
- ip_version
- policy_address or
policy_address6 (depending on the
setting of the ip_version keyword)
- start_port and end_port
- service_type
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
Keyword Associated Keyword to
Select or Parameter to Type
Description