NETGEAR ProSAFE SRX5308 - Page 68

Net Mode Configuration Commands
68
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net lan ipv6 pool add
This command configures a new IPv6 DHCP address pool for the LAN. After you have issued
the net lan ipv6 pool add command, you enter the net-config [lan-ipv6-pool] mode,
and then you can configure the IPv6 start and end addresses and the IPv6 prefix length for
the IPv6 pool in the order that you prefer.
Command example:
SRX5308> net lan ipv6 pool add
net-config[lan-ipv6-pool]> start_address 2001::1025
net-config[lan-ipv6-pool]> end_address 2001::1030
net-config[lan-ipv6-pool]> prefix_length 56
net-config[lan-ipv6-pool]> save
Related show command: show net lan ipv6 setup
net lan ipv6 pool edit <row id>
This command configures an existing IPv6 DHCP address pool for the LAN. After you have
issued the net lan ipv6 pool edit command to specify the row to be edited, you enter
the net-config [lan-ipv6-pool] mode, and then you can configure the IPv6 start and end
addresses and the IPv6 prefix length for the IPv6 pool in the order that you prefer.
Step 1 Format net lan ipv6 pool add
Mode net
Step 2 Format start_address <ipv6-address>
end_address <ipv6-address>
prefix_length <prefix length>
Mode net-config [lan-ipv6-pool]
Keyword Associated
Parameter to Type
Description
start_address ipv6-address The start address of the IPv6 address pool.
end_address ipv6-address The end address of the IPv6 address pool.
prefix_value prefix length The prefix length for the IPv6 address pool.
Step 1 Format net lan ipv6 pool edit <row id>
Mode net