NETGEAR ProSAFE SRX5308 - Page 69

Net Mode Configuration Commands
69
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show command: show net lan ipv6 setup
net lan ipv6 pool delete <row id>
This command deletes an IPv6 DHCP address pool by specifying its row ID.
Related show command: show net lan ipv6 setup
net lan ipv6 multi_homing add
This command configures a new IPv6 alias, that is, a secondary IPv6 address. After you
have issued the net lan ipv6 multi_homing add command, you enter the
net-config [lan-ipv6-multihoming] mode, and then you can configure the secondary address
and IPv6 prefix length in the order that you prefer.
Step 2 Format start_address <ipv6-address>
end_address <ipv6-address>
prefix_length <prefix length>
Mode net-config [lan-ipv6-pool]
Keyword Associated
Parameter to Type
Description
start_address ipv6-address The start address of the IPv6 address pool.
end_address ipv6-address The end address of the IPv6 address pool.
prefix_value prefix length The prefix length for the IPv6 address pool.
Format net lan ipv6 pool delete <row id>
Mode net
Step 1 Format net lan ipv6 multi_homing add
Mode net
Step 2 Format ip_address <ipv6-address>
prefix_length <prefix length>
Mode net-config [lan-ipv6-multihoming]