NETGEAR ProSAFE SRX5308 - Page 71

Net Mode Configuration Commands
71
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net lan ipv6 multi_homing delete <row id>
This command deletes a secondary IPv6 address by specifying its row ID.
Related show command: show net lan ipv6 multiHoming
net radvd configure lan
This command configures the Router Advertisement Daemon (RADVD) for the link-local
advertisements of IPv6 router addresses and prefixes in the LAN. After you have issued the
net radvd configure lan command, you enter the net-config [radvd-lan] mode, and
then you can configure one keyword and associated parameter or associated keyword at a
time in the order that you prefer.
Format net lan ipv6 multi_homing delete <row id>
Mode net
Step 1 Format net radvd configure lan
Mode net
Step 2 Format enable {Y | N}
mode {Unsolicited-Multicast | Unicast-Only}
interval <seconds>
flags {Managed | Other}
preference {Low | Medium | High}
mtu <number>
life_time <seconds>
Mode net-config [radvd-lan]
Keyword (might consist
of two separate words)
Associated Keyword to
Select or Parameter to Type
Description
enable Y or N Enables the RADVD process to allow stateless
autoconfiguration of the IPv6 LAN or disables the
RADVD process.
mode Unsolicited-Multicast
or Unicast-Only
Specifies the advertisement mode:
• Unsolicited-Multicast. Allows unsolicited
multicast and unicast communication with the
hosts. Router advertisements (RAs) are sent to
all interfaces at the rate that is defined by the
interval keyword and parameter.
• Unicast-Only. Responds to unicast packet
requests only. No unsolicited packets are
advertised.