NETGEAR ProSAFE SRX5308 - Page 87

Net Mode Configuration Commands
87
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
[network-qos-profile] mode, and then you can configure one keyword and associated
parameter or associated keyword at a time in the order that you prefer.
Step 1 Format net qos profile edit <row id>
Mode net
Step 2 Format The following settings apply to both rate control profiles and priority profiles:
qos_type {Rate-Control | Priority}
interface {WAN1 | WAN2 | WAN3 | WAN4}
service_name {default_services <default service name> |
{custom_services <custom service name>}
diffserv_qos_match <number>
diffserv_qos_remark <number>
The following settings apply only to rate control profiles:
direction_for_rate_control {Inbound | Outbound | Both}
congestion_priority {Default | High | Medium-high | Medium | Low}
hosts {Single-IP-Address {hosts_start_ip <ipaddress>} |
IP-Address-Range {hosts_start_ip <ipaddress>} {hosts_end_ip
<ipaddress>} | Group {hosts_group {Group1 | Group2 | Group3 |
Group4 | Group5 | Group6 | Group7 | Group8}}
}
bandwidth_allocation {Shared | Individual}
outbound_min_bandwidth <bandwidth>
outbound_max_bandwidth <bandwidth>
inbound_min_bandwidth <bandwidth>
inbound_max_bandwidth <bandwidth>
The following settings apply only to priority profiles:
direction_for_priority {Inbound-Traffic | Outbound-Traffic}
priority {Low | High}
Mode net-config [network-qos-profile]
Keyword (might consist of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description
Common settings
qos_type Rate-Control or
Priority
Specifies the type of profile:
• Rate-Control. Configure the keywords
and parameters in the Common settings
section and Rate control profile settings
section of this table.
• Priority. Configure the keywords and
parameters in the Common settings
section and Priority profile settings
section of this table.
interface WAN1, WAN2, WAN3, or
WAN4
Specifies the interface to which the profile
applies.