NETGEAR ProSAFE SRX5308 - Page 89

Net Mode Configuration Commands
89
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Rate control profile settings
direction_for_rate_control Inbound, Outbound, or
Both
Specifies the direction to which rate
control is applied:
• Inbound. Rate control is applied to
inbound packets only. You need to issue
the inbound_min_bandwidth and
inbound_max_bandwidth keywords
and specify the bandwidth that is
allocated.
• Outbound. Rate control is applied to
outbound packets only. You need to
issue the outbound_min_bandwidth
and outbound_max_bandwidth
keywords and specify the bandwidth that
is allocated.
• Both. Rate control is applied to both
inbound and outbound packets. You
need to issue the
inbound_min_bandwidth,
inbound_max_bandwidth,
outbound_min_bandwidth, and
outbound_max_bandwidth keywords
and specify the bandwidth that is
allocated.
congestion_priority Default, High,
Medium-high, Medium,
or Low
Specifies the priority queue that
determines the allocation of excess
bandwidth and the classification level of
the packets among other priority queues
on the VPN firewall:
• Default. Traffic is mapped based on the
ToS field in the packet’s IP header.
• High. This queue includes the following
DSCP values: AF41, AF42, AF43, AF44,
and CS4.
• Medium-high. This queue includes the
following DSCP values: AF31, AF32,
AF33, AF34, and CS3.
• Medium. This queue includes the
following DSCP values: AF21, AF22,
AF23, AF24, and CS2.
• Low. This queue includes the following
DSCP values: AF11, AF12, AF13, AF14,
CS1, 0, and all other values.
Keyword (might consist of two
separate words)
Associated Keyword to
Select or Parameter to Type
Description