200 – Troubleshooting
CX2731 MFP Basic User’s Guide
Please check Belt Unit: 330
Problem
The belt unit is not properly installed.
Solution
Reinstall it properly. See page 225.
Fuser Unit Near Life.
Problem
The fuser will need to be replaced soon.
Solution
Make sure you have a replacement fuser on hand.
Please change Fuser Unit.
Problem
The fuser needs to be replaced.
Solution
Replace the fuser unit. See page 233.
Note
If the machine is in the middle of a print job, it will temporarily
stop printing the job until the fuser is replaced.
Please check Fuser Unit: %ERRCODE%
Problem
The fuser unit is not properly installed.
Solution
Reinstall it properly. See page 233.
To Next Page
Loading...
Need help?
General
