84 – Faxing
CX2731 MFP Basic User’s Guide
6 Press <Mono Start> to start the transmission.
When you want to scan multiple documents as a single fax job
using the document glass, enable the continuous scan mode. For
details on the continuous scan mode, see page 76.
Note
• When you want to specify multiple destinations, refer to the
Advanced User’s Guide at www.my.okidata.com.
• For details on how to configure each fax function, see page 89.
Specifying a Destination
You can specify a destination in the following ways:
• Using the keypad (see below)
• Using speed dial (see page 86)
• Using a group list (see page 86)
• Using the transmission histories
• Using the reception histories
• Using the One-Touch keypad
Perform the following procedures at step 5 of “Sending a Fax”
described above.
Direct Input: Using the Keypad
You can enter up to 40 digits using the keypad.
1 Make sure that [Add destination] is selected on the fax standby
screen, then press <OK>.
2 Press the down arrow key repetitively to scroll down to [Direct
Input], then press <OK>.
To Next Page
Loading...
Need help?
General
