Servicing an Internal USB Flash Drive (CRU)
This section describes how to service a USB flash drive. The USB flash drive is a customer-
replaceable unit (CRU) that requires you to power off the server. For more information
about CRUs, see “Illustrated Parts Breakdown” on page 20 and “Customer-Replaceable
Units” on page 21.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in “Electrostatic Discharge
Safety” on page 52.
Caution - Ensure that all power is removed from the server before removing or installing a
flash drive or damage to the drive might occur. You must disconnect all power cables from the
system before performing these procedures.
This section covers the following procedures:
■
“Remove an Internal USB Flash Drive” on page 109
■
“Install an Internal USB Flash Drive” on page 110
Related Information
■
“USB Ports” on page 229
Remove an Internal USB Flash Drive
The server can be equipped with one internal USB Flash drive.
1.
Prepare the server for service.
a.
Power off the server, and disconnect the power cords from the server power
supplies.
See “Powering Down the Server” on page 55.
Servicing an Internal USB Flash Drive (CRU) 109
To Next Page
Loading...
Need help?
General
