Servicing NVMe Cables (FRU)
The following section describes how to service NVMe cables. NVMe cables are field-
replaceable units (FRUs). For more information about FRUs, see “Illustrated Parts
Breakdown” on page 20 and “Field-Replaceable Units” on page 22.
Caution - NVMe cables should be removed and replaced only by authorized Oracle Service
personnel.
Caution - The system supplies power to the cables even when the server is powered off.
To avoid personal injury or damage to the server, you must disconnect power cords before
servicing the cables.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow electrostatic discharge safety measures and antistatic practices. See
“Electrostatic Discharge Safety” on page 52.
This section covers the following procedures:
■
“Remove NVMe Cables” on page 195
■
“Install NVMe Cables” on page 198
■
“Verify NVMe Cable Connections” on page 200
Related Information
■
“Servicing Storage Drives (CRU)” on page 69
■
“Servicing the Disk Backplane (FRU)” on page 159
■
“Servicing SAS Cables (FRU)” on page 189
Remove NVMe Cables
1.
Prepare the server for service.
Servicing NVMe Cables (FRU) 195
To Next Page
Loading...
Need help?
General
