USB Ports
Related Information
■
“Back Panel Components and Cable Connections” on page 18
■
“Disconnect Cables From the Server” on page 61
■
“Reconnect Power and Data Cables” on page 222
USB Ports
The server has two USB ports for attaching supported USB 3.0–compliant devices. One USB
port is on the back panel and one USB port is located on the motherboard. The following figure
and table describe the USB port pin signals.
TABLE 9
USB Port Signals
Pin
Signal Description
1 +5 V
2 USB 2.0 DAT-
3 USB 2.0 DAT+
4 Ground
5 USB 3.0 RX-
6 USB 3.0 RX+
7 Ground
8 USB 3.0 TX-
9 USB 3.0 TX+
Related Information
■
“Back Panel Components and Cable Connections” on page 18
■
“Disconnect Cables From the Server” on page 61
■
“Reconnect Power and Data Cables” on page 222
Identifying the Server Ports 229