Servicing Processors (FRU)
The following section describes how to service processors. Processors are field-replaceable
units (FRUs). For more information about FRUs, see “Illustrated Parts Breakdown” on page 20
and “Field-Replaceable Units” on page 22.
Caution - Processors must be removed and replaced only by authorized Oracle Service
personnel.
Caution - Ensure that all power is removed from the server before removing or installing a
processor. You must disconnect the power cables from the system before performing these
procedures.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow electrostatic discharge safety measures and antistatic practices. See
“Electrostatic Discharge Safety” on page 52.
Note - On single-processor systems, processor socket 1 (P1) is shipped without a heatsink and
processor filler cover. To protect the delicate processor socket pins, do not remove the processor
cover that was installed on the motherboard.
This section covers the following topics:
■
“Identify and Remove a Processor” on page 146
■
“Install a Processor” on page 152
Related Information
■
“Servicing the DIMMs (CRU)” on page 119
Servicing Processors (FRU) 145
To Next Page
Loading...
Need help?
General
