Servicing the Temperature Sensor (FRU)
The following section describes how to service the temperature sensor. The temperature sensor
is a field-replaceable unit (FRU). For more information about FRUs, see “Illustrated Parts
Breakdown” on page 20 and “Field-Replaceable Units” on page 22.
Caution - The temperature sensor should be removed and replaced only by authorized Oracle
Service personnel.
Caution - Ensure that all power is removed from the server before removing or installing the
temperature sensor. You must disconnect the power cables before performing this procedure.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow electrostatic discharge safety measures and antistatic practices. See
“Electrostatic Discharge Safety” on page 52.
This section covers the following procedures:
■
“Remove the Temperature Sensor” on page 175
■
“Install the Temperature Sensor” on page 178
Related Information
■
“Troubleshooting Using the Server Front and Back Panel Status Indicators” on page 30
Remove the Temperature Sensor
1.
Prepare the server for service.
a.
Power off the server and disconnect the power cords from the power
supplies.
Servicing the Temperature Sensor (FRU) 175
To Next Page
Loading...
Need help?
General
