Servicing the Front LED Indicator Module (FRU)
The following section describes how to service the front LED indicator module. The front LED
indicator module is a field-replaceable unit (FRU). For more information about FRUs, see
“Illustrated Parts Breakdown” on page 20 and “Field-Replaceable Units” on page 22.
Caution - The front LED indicator modules should be removed and replaced only by authorized
Oracle Service personnel.
Caution - Ensure that all power is removed from the server before removing or installing a
front LED indicator module. You must disconnect the power cables before performing this
procedure.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow electrostatic discharge safety measures and antistatic practices. See
“Electrostatic Discharge Safety” on page 52.
This section covers the following procedures:
■
“Remove the Front LED Indicator Module” on page 167
■
“Install the Front LED Indicator Module” on page 171
Related Information
■
“Troubleshooting Using the Server Front and Back Panel Status Indicators” on page 30
Remove the Front LED Indicator Module
1.
Prepare the server for service.
Servicing the Front LED Indicator Module (FRU) 167
To Next Page
Loading...
Need help?
General
