Servicing SAS Cables (FRU)
The following section describes how to service SAS cables. SAS cables are field-replaceable
units (FRUs). For more information about FRUs, see “Illustrated Parts Breakdown” on page 20
and “Field-Replaceable Units” on page 22.
Caution - SAS cables should be removed and replaced only by authorized Oracle Service
personnel.
Caution - The system supplies power to the cables even when the server is powered off.
To avoid personal injury or damage to the server, you must disconnect power cords before
servicing the cables.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow electrostatic discharge safety measures and antistatic practices. See
“Electrostatic Discharge Safety” on page 52.
This section covers the following procedures:
■
“Remove SAS Storage Drive Cables” on page 189
■
“Install SAS Storage Drive Cables” on page 192
Related Information
■
“Servicing Storage Drives (CRU)” on page 69
■
“Servicing the Disk Backplane (FRU)” on page 159
■
“Servicing NVMe Cables (FRU)” on page 195
Remove SAS Storage Drive Cables
1.
Prepare the server for service.
Servicing SAS Cables (FRU) 189
To Next Page
Loading...
Need help?
General
