Required Tools
When a server FRU that contains the KIP is removed and a replacement component is installed,
the KIP of the replacement component is programmed by Oracle ILOM to contain the same
KIP as the other two components.
Note - Only one of the quorum members can be replaced at a time. Automated updates can only
be completed when two of the three quorum members contain matching key identity properties.
Related Information
■
“Servicing Power Supplies (CRU)” on page 93
■
“Servicing the Disk Backplane (FRU)” on page 159
■
“Servicing the Motherboard Assembly (FRU)” on page 203
Required Tools
The server can be serviced with the following tools:
■
Antistatic wrist strap
■
Antistatic mat
■
No. 2 Phillips screwdriver
■
Torx (6 lobe) T10, T15, T25, and T30 screwdrivers
■
12.0 in-lbs/ft (inch-pounds/foot) torque driver
Related Information
■
“Preparing for Service” on page 51
Preparing the Server for Component Replacement
Note - When you are replacing the storage drives or power supplies, not all of these procedures
are necessary. See the replacement procedures for those components for more information.
Before you can remove and install components that are inside the server, you must perform the
procedures in some or all of the following sections:
54 Oracle Server X8-2L Service Manual • January 2021
To Next Page
Loading...
Need help?
General
