Oracle X8-2L

BIOS Advanced Menu Selections
Setup Options Options Defaults Description
bit indicates the beginning
of a serial data packet.) The
standard setting is 1 stop bit.
Communication with slow
devices may require more than 1
stop bit.
Flow Control None, Hardware RTS/CTS,
Software Xon/Xoff
None Flow control can prevent data
loss from buffer overflow. When
sending data, if the receiving
buffers are full, a 'stop' signal
can be sent to stop the data flow.
Once the buffers are empty, a
'start' signal can be sent to restart
the flow. Hardware flow control
uses two wires to send start/stop
signals.
BIOS Advanced Menu Network Stack Options
The following table describes the BIOS Advanced Menu network stack options.
Setup Options Options Defaults Description
Network Stack Disabled/Enabled Enabled Enable or disable the UEFI
network stack.
Ipv4 PXE Support Disabled/Enabled Enabled Enable or disable IPv4 PXE
Boot support. If disable, the
IPv4 PXE Boot Option will not
be created.
Ipv4 HTTP Support Disabled/Enabled Disabled Enable or disable IPv4 HTTP
Boot support. If disable, the
IPv4 HTTP Boot Option will not
be created.
Ipv6 PXE Support Disabled/Enabled Disabled Enable or disable IPv6 PXE
Boot support. If disable, the
IPv6 PXE Boot Option will not
be created.
Ipv6 HTTP Support Disabled/Enabled Disabled Enable or disable IPv6 HTTP
Boot support. If disable, the
IPv6 HTTP Boot Option will not
be created.
PXE boot wait time 0 0 Wait time to press ESC key to
abort the PXE boot.
Media detect count 1 1 Number of times the presence of
media will be checked.
268 Oracle Server X8-2L Service Manual • January 2021