Install the Temperature Sensor
4.
Reconnect the temperature sensor cable to the disk backplane.
5.
Install the fan tray and fan modules.
See “Install the Fan Tray” on page 90 and “Install a Fan Module” on page 87.
6.
Return the server to operation.
a.
Install the server top cover.
See “Install the Server Top Cover” on page 218.
b.
Return the server to the normal rack position.
See “Return the Server to the Normal Rack Position” on page 220.
c.
Reconnect the power cords to the power supplies, and power on the server.
See “Reconnect Power and Data Cables” on page 222 and “Power On the
Server” on page 222.
d.
Verify that the power supply AC OK LED is lit.
Related Information
■
“Remove the Temperature Sensor” on page 175
Servicing the Temperature Sensor (FRU) 179
To Next Page
Loading...
Need help?
General
