Oracle X8-2L Service Manual

BIOS Advanced Menu Selections
Setup Options Options Defaults Description
then the iSCSI driver attempt to
connect using the IPv6 stack.
Connection Retry Count 0 to 16 0 The count range is 0 to 16. If set
to 0, there are no retries.
Connection Establishing
Timeout
NA 1,000 The timeout value in
milliseconds. The minimum
value is 100 milliseconds and
the maximum is 20 seconds.
Configure ISID Derived from the MAC address The default value is derived
from the MAC address
The OUI-format ISID is 6 bytes.
The default value is derived
from the MAC address. Only the
last 3 bytes are configurable.
Example: Update
0ABBCCDDEEFF to
0ABBCCF07901 by inputting
F07901
Enable DHCP Disabled/Enabled Disabled Enable or disable DHCP.
Initiator IP Address NA 0.0.0.0 Set initiator IP address in dotted-
decimal notation.
Initiator Subnet Mask NA 0.0.0.0 Set initiator subnet mask IP
address in dotted-decimal
notation.
Gateway NA 0.0.0.0 Set initiator gateway IP address
in dotted-decimal notation.
Target Name NA NA The worldwide unique name of
the target. Only IQN format is
accepted.
Target IP address 0.0.0.0 None Set target IP address in dotted-
decimal notation.
Target Port 3260 Change target port number.
Boot LUN 0 Set the hexadecimal
representation of the boot logical
unit number (LUN).
Example: 4752-3A4F-6b7e-
2F99
Authentication Type CHAP/None CHAP Define the Challenge-
Handshake Authentication
Protocol (CHAP). Available
settings are CHAP, Kerberos,
and None.
CHAP Type One Way/Mutual One Way Set CHAP type to either One
Way or Mutual.
CHAP Name NA None Set CHAP name.
278 Oracle Server X8-2L Service Manual • January 2021

Oracle X8-2L Specifications

General

Brand	Oracle
Model	X8-2L
Category	Server
Language	English