Install the Fan Tray
1.
Lower the fan tray into the server [1].
2.
Using a Torx T25 screwdriver, tighten the three spring-mounted screws that
secure the fan tray to the server chassis [2].
3.
Continue with the next step in the service procedure.
Related Information
■
“Install a Fan Module” on page 87
■
“Servicing the Disk Backplane (FRU)” on page 159
■
“Servicing SAS Cables (FRU)” on page 189
■
“Servicing NVMe Cables (FRU)” on page 195
■
“Servicing the Motherboard Assembly (FRU)” on page 203
Servicing Fan Modules (CRU) 91
To Next Page
Loading...
Need help?
General
