Panasonic DP-2330

368
DP-2330/3030
MAR 2005
Ver.2.1
DP-2310/3010
(37) Connect the PTC-AC Harness 3 to the HT3
Harness.
(38) Insert the HT3 Harness and PTC-AC Harness 3
to 2 Harness Clamps.
(39) Route the HT3 Harness to the lower section of
the frame as illustrated.
(40) Mount the Heater onto the Heater Bracket.
(41) Remove the LSU Unit.
(Refer to 2.2.10. of the Service Manual)
(42) Connect the Heater Assembly to the PTC-AC
Harness 3.
(43) Install the Heater Assembly.
(44) Secure the Heater Assembly with 1 Screw
(XTB3+4F).
(45) Install the Harness Clamp.
(46) Insert the PTC-AC Harness 3 to 2 Harness
Clamps.
(47) Route the PTC-AC Harness 3 to the rear section
of the frame through the access hole as
illustrated.
(48) Slide the 1st Paper Tray out.
(49) Install the Protection Sheet.