Chapter 4
Using Pipeline Direct
56
March, 2009
3. Download the Pipeline firmware file (firmware-xxxxx.pln) file to your computer.
Upgrade Steps
After downloading the firmware file, upgrade the firmware by following these steps:
1. Log on to the target Pipeline.
2. Select Upgrade from the menu to display the Upgrade panel.
3. Click Choose File to locate and select the firmware file (firmware.xxxxx.pln) you plan to use.
4. Click Upgrade and observe the progress bar and notes about the process.
During a firmware upgrade, the front SDI In LED (on left) lights yellow during the upgrade process.
When the Pipeline has been upgraded, Pipeline Direct reboots the Pipeline and displays a rebooting
message on the Upgrade page. In about 15 to 30 seconds, both the In and Power LEDs light green.
Pipeline Direct reconnects automatically and displays the Configure panel.
5. When you display the live panel, Pipeline Direct may display an installation message in the preview
panel: “Click here to install the following ActiveX control: Pipeline Library, from Telestream, Inc.” Click to
install the activeX control, and click Install on the installer window.
Note
The first time you display the live panel after upgrading, you may have to install the
Pipeline Library.
To Next Page
Loading...