2.56
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
BATTERY INSTALLATION (INTL)
NOTICE
Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can
also hinder vehicle performance. Refer to “Battery
Charging” page procedure before installing the
battery.
1. Place the battery in the battery holder and secure
with hold-down strap. Torque fastener to
specification.
TORQUE
Battery Bracket:
3.5 lb-ft (5 Nm)
2. Coat the terminals with dielectric grease.
3. Connect and tighten the red (+)
q
cable first.
4. Connect and tighten the black (-)
w
cable last.
5. Verify that cables are properly routed and reinstall the
driver’s seat.
ENGINE / CHASSIS ELECTRICAL
GROUND
Inspect the ground cable connections. Remove ground
terminals and clean if necessary.
1. The chassis ground connection
w
, located below the
start solenoid
q
, can be accessed through the left
rear wheel area.
2. Inspect the chassis ground terminals. Be sure the
grounds are clean and tight.
MAINTENANCE
To Next Page
Loading...
Need help?
General
