13
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
13.25
WINCH SWITCH
PIN CONTINUITY
SWITCH POSITION CONTINUITY BETWEEN
Out Pins 2 and 3
Off
NO continuity between
pins 2 and 3; 1 and 2
In Pins 1 and 2
SWITCH FUNCTION
PIN FUNCTION
1 Winch Switch In
2
Switched B+, Winch
Switch
3 Winch Switch Out
4
—
5
—
6
—
7
Ground, Winch Switch
8
Key Switch B+, Winch
Switch Light
9
Ground, Winch Switch
10
Key Switch B+, Winch
Switch Light
TESTING
1. Disconnect the winch switch harness on the back
side of the center console by depressing the
connector locks and pulling on the connector. Do not
pull on the wiring.
2. Test between the 3 sets of outputs (ON / OFF / ON). If
any of the tests fail, replace winch switch assembly.
• Move the switch to Position 1, ON. There should be
continuity (< 1 Ω) between switch pins 2 and 3.
• Move the switch to Position 2, OFF. There should
be NO continuity (∞ - OL) between switch pins 2
and 3; 1 and 2.
• Move the switch to Position 3, ON. There should be
continuity (< 1 Ω) between switch pins 1 and 2.
FACTORY-INSTALLED OPTIONS
To Next Page
Loading...
Need help?
General
