3.8
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
ENGINE BREAK-IN PERIOD
The break-in period consists of the first 25 hours of
operation, or the time it takes to use 15 gallons (57 liters)
of fuel. Careful treatment of a new engine and drive
components will result in more efficient performance and
longer life for these components.
IMPORTANT
Use only recommended Engine Oil.
Never substitute or mix oil brands. Serious engine
damage and voiding of warranty can result.
Do not operate at full throttle or high speeds for
extended periods during the first three hours of use.
Excessive heat can build up and cause damage to
close fitted engine parts.
1. Fill fuel tank with unleaded fuel which has a minimum
pump octane number of 87 = (R + M)/2.
2. Check oil level indicated on dipstick. Add oil if
necessary. Refer to “Engine Oil Level” page 2.27
procedure.
3. Drive slowly at first to gradually bring engine up to
operating temperature.
4. Vary throttle positions. Do not operate at sustained
idle or sustained high speed.
5. Perform regular checks on fluid levels, controls and
all important bolt torques.
6. Change oil and oil filter after 25 hour break-in period.
7. Pull only light loads.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
