Cylinder Head and Valves
02
020
43
RG,RG34710,92 –19–28NOV00–5/6
RG8155 –UN–05DEC97
Installing Guide Support Bar
RG8157 –UN–05DEC97
Guide Support Bar Cap Screw
RG8156 –UN–05DEC97
Guide Sleeve Arbor Nut
A—JDG981-3 Guide Sleeve Holding Bar
B—220213 (8 mm) Cap Screw
C—220089 (16 mm) Cap Screw
D—JDE131-2 Driver Nut
NOTE: Carefully inspect threads on 8 mm cap screw prior
to use to avoid damaging injector hold-down
clamp threads in cylinder head. Replace cap
screw as needed.
4. Install JDG981-3 Guide Sleeve Holding Bar (A) as
shown. Install 220213 (8 mm) cap screw (B) finger
tight.
5. Install 220089 (16 mm) cap screw (C) from combustion
face side of head using a phosphate washer from
cylinder head mounting cap screw finger tight.
6. Install JDE131-2 Driver Nut (D) finger tight.
7. Tighten cap screws and nut in following order to
specification given:
• 16 mm Cap Screw (C) to 115 N•m (85 lb-ft)
• 8 mm Cap Screw (B) to 47 N•m (35 lb-ft)
• Guide Sleeve Nut (D) to 150 N•m (110 lb-ft)
Continued on next page
CTM100 (06APR04)
02-020-43
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=115
To Next Page
Loading...