Cylinder Head and Valves
02
020
44
RG,RG34710,92 –19–28NOV00–6/6
RG10279 –UN–13AUG99
Using Expansion Arbor
RG8159 –UN–21MAY98
Installed Injector Sleeve
A—JDG1184-2-1 Swedge Arbor
B—8132 Adapter
C—D01300AA Slide Hammer
8. Clean and inspect JDG1184-2-1 Swedge Arbor (A) for
raised or foreign material.
IMPORTANT: DO NOT use JDG981-2 Swedge, this
tool is obsolete. Use only JDG1184-2-1
Swedge and 8132 Adapter.
9. Assemble small end of 8132 Adapter (B) onto swedge
arbor (A).
10. Assemble large end of adapter onto D01300AA 2.2
kg (5 lb) Slide Hammer (C).
11. Position tip of swedge into guide sleeve and drive
swedge through sleeve tip. Withdraw swedge with
slide hammer.
12. Remove injector sleeve replacement tool set from
cylinder head and inspect for proper installation of
injector sleeve.
13. Repeat procedure on remaining injector sleeves.
CTM100 (06APR04)
02-020-44
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=116
To Next Page
Loading...