Cylinder Head and Valves
02
020
48
DPSG,OUO1004,929 –19–16JUL99–4/15
RG9161A –UN–21JUL99
JDG1184-1-3 Protector Sleeve
A—JDG1184-1-3 Protector Sleeve
IMPORTANT: DO NOT attempt to tap threads in
injector sleeve (for removal) unless
JDG1184-1-3 Protector Sleeve (A) is
anchored against injector sleeve with
EUI hold-down clamp. This will
eliminate injector sleeve turning in
swedged bore of cylinder head.
11. Thoroughly clean and dry JDG1184-1-3 Protector
Sleeve as needed. Install protector sleeve into EUI
bore until it is seated with injector sleeve.
DPSG,OUO1004,929 –19–16JUL99–5/15
RG9162A –UN–21JUL99
Hold-Down Cap Screw
A—Hold-Down Cap Screw
12. Install EUI hold-down clamp and cap screw (A) over
protector sleeve. Tighten cap screws to 40 N•m (30
lb-ft).
Continued on next page
CTM100 (06APR04)
02-020-48
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=120
To Next Page
Loading...