Cylinder Head and Valves
02
020
51
DPSG,OUO1004,929 –19–16JUL99–10/15
RG12418 –UN–04SEP02
Installing Sleeve
RG12415 –UN–04SEP02
A—Injector Sleeve
B—Old Injector Sleeve
C—New Injector Sleeve
5. Lubricate new square packing with clean engine oil or
grease and install into packing bore in cylinder head.
IMPORTANT: Old injector sleeve (B) with one O-ring
MUST be replaced with new injector
sleeve (C) with two O-rings.
6. Lubricate O-rings with engine oil and install injector
sleeve (A) into cylinder bore.
DPSG,OUO1004,929 –19–16JUL99–11/15
RG9167A –UN–21JUL99
Seat Sleeve
A—JDG981-1 Guide Sleeve
7. Lubricate O-rings with clean engine oil and position
JDG981-1 Guide Sleeve (A) into injector sleeve and
seat sleeve using a plastic or rubber hammer. Be
careful not to cut O-rings.
NOTE: When injector sleeve is fully seated, top of
JDG981-1 Guide Sleeve should be slightly lower
than top of valve rotators.
CTM100 (06APR04)
02-020-51
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=123
Continued on next page
To Next Page
Loading...