Cylinder Head and Valves
02
020
50
DPSG,OUO1004,929 –19–16JUL99–8/15
RG8226 –UN–05DEC97
Rotate Engine Flywheel
A—JDG820 Flywheel Rotation Tool
Check Piston Position in Liner
1. After injector sleeve is removed, look into sleeve bore
of cylinder head to be sure that piston is at or near
bottom of its stroke.
2. If piston is not near bottom, rotate engine flywheel
using JDG820 Flywheel Rotation Tool (A).
DPSG,OUO1004,929 –19–16JUL99–9/15
RG9162B –UN–21JUL99
Install Protector Sleeve
A—JDG1184-1-3 Protector Sleeve
B—Hold-Down Clamp
Install Injector Sleeve
1. Install JDG1184-1-3 Protector Sleeve (A) into injector
sleeve bore (without injector sleeve).
2. Install EUI hold-down clamp (B) and cap screw over
protector sleeve. Tighten cap screw to 40 N•m (30
lb-ft).
3. Thoroughly clean injector sleeve bore with a small
brush.
4. Remove protector sleeve.
Continued on next page
CTM100 (06APR04)
02-020-50
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=122
To Next Page
Loading...