Cylinder Block, Liners, Pistons, and Rods
02
030
2
RG,RG34710,106 –19–01NOV00–2/4
NOTE: Older front plate gaskets required the use of
sealant on some of the upper threaded cap
screw holes. New service gaskets are
rubberized in these locations, so sealant is no
longer required.
7. Remove gasket (G) and discard. Thoroughly clean
gasket surfaces on cylinder block and front plate. If
present, ensure all sealant is removed.
Continued on next page
CTM100 (06APR04)
02-030-2
P
OWER
T
ECH
10.5 L & 12.5 L Diesel Engines
040604
PN=142
To Next Page
Loading...