Section 18: BODY
PA1562
52
Section B Sika 205
1. Apply
2. Allow drying
- For a smooth surface (aluminum, stainless,
steel, fiber glass (gelcoat side), etc.):
2 minutes Mandatory
Minimum
time
- Pour a porous surface (fiber glass (non
gelcoat side), etc.)
10 minutes
After 2 hours : Reactivate surface with Sika 205
Before applying any
other product
If surface seems dusty, greasy or with finger marks, start
operation again.
SECTION 3 SIDE PANEL INSTALLATION
A) Using a pencil, mark the double-face self adhesive tape
position onto vehicle side.
B) Apply 1/8 X ½”double-face tape as per marking.
C) Compress tape
3.00
D) Remove protective film from double-face self adhesive
tape center section.
CHIX cloth
To Next Page
Loading...
